APPLICATION PROCESS

The 12 steps to an Ceramic Coatings job.



1. Initial Inspection: It is important that an initial inspection be done on the first visit to your property. Any visible surfaces that need to be replaced or repaired will be noted and included in the work order and total price.

 

2. Trenching: A trench of 3″-6″ is dug out around the  foundation if it is  being coated to assume the coating film goes below grade. This eliminates moisture from sinking up and under the coating.


 

3. Pressure Washing: This step removes dirt, mold, and mildew. We first apply a mixture of a fungicide (bleach works well) and soap. This mixture kills mold spores and is blasted off using “moderate” pressure. Stubborn areas are treated again, until surfaces are clean. Pressure washing is NOT used to strip off old loose paint to avoid damage to the surfaces. (A second inspection for any wood  that requires replacing is done during this step.)


 


4. Masking: All areas that are not being coated are masked off by taping and sometimes temporarily removing items such as house numbers, mailboxes, some light fixtures, etc. Special care is taken with shrubs, decks, lawns, etc. to manage over spray.

 


5. Caulking: This step is very important to seal around doors and windows, corners, over hangs, and other siding  and trim areas, we are very thorough with this step of the process and use a commercial grade Elastomeric Eura theme sealant. The sealant we use for this will always stay very flexible so it will expand and contact with the house during seasonal temperature changes.


 

6. Patch & Repair: In this step, we fill holes, cracks, dings,  etc. and work on minor cosmetic type of repairs.

 


7. Priming: Our Ceramic Coating Adhesive Primer is applied to all areas that are being coated. This waterproof adhesive bonds so tightly , on an actual molecular level. That becomes a permanent surface of the substrate. In some situations, we will use special primers in addition to the adhesive. this would typically be to control rust or bleed through from knots or various types of wood that are prone to tannin. Tannin is a term used for Tanic Acid that can sometimes leach out of wood for years.

 

 

8. Mid-coat (optional)

 


9. Application of the Ceramic Finish Coat: This is the color coat. This application is usually done with one coat, even if there is an extreme change from the previous color. The dry film thickness of Ceramic Coating Finish Coat is  an average of 12 times thicker than traditional house paint (depending on the surface it is applied to). 

 

 

10. Detail Touch-Up: After the Finish Coat is dry to the touch, a detailed touch up is done to ensure that all surfaces are completely encapsulated. Masking is removed and any parts that were removed for the process  are re installed.

 


11. Clean up Job Site: We will keep the job site clean on a daily basis. After the job is completed, a final clean up  is done and all debris from the job are removed from the  property.


 


12. Final inspection: The crew leader will do a final walk around with the home owner to be sure that everything is complete and you are 100% satisfied. Our crews will be proud of the final results and will attend to handle any issues that may come up.

 

 

 

 

Interested in an estimate?

Before and After

Print | Sitemap
© Al-Technologies,inc